Publicité
Les langues disponibles
Les langues disponibles
Microscopy
Microscopes IRIO MS / ES / EPS / EPSA
Ref : 571 210 - 571 211
571 212 - 571 261
ENGLISH
- Integral lighting N: you benefit from good quality, cold, durable lighting and its
intensity is adjustable with the potentiometer O. The emission spectrum of
the LEDs (LED indicators) does not require the addition a blue filter.
It is recommended to begin the observation always with the luminous
intensity set to its minimum (button stopped towards the left).
Lighting block (Reference 574 241)
This low voltage built-in lamp allows for the transformation of your mirror
microscope IRIO-MS to a lighting model without any technical assistance.
This easy to assemble kit contains:
- A lighting unit with the LED bulbs, the adjustment potentiometer, and an
outlet,
- A power supply with jack connection to the lighting unit,
- The fixture screws and a protection mask,
- A detailed manual with pictures.
Tools required: the IRIO adjustment key and two screwdrivers.
Remove the mirror unit and clip the lighting unit at the same location. Turn the
microscope down and install the power supply unit (see the manual provided
with the ref. 574 241).
- Power supply: built-in transformer unit G 12 V / 160 mA / 2 VA located in the
stand C: no encumbrance of the low voltage wall socket.
5 How to settle (adjust) the hardness of the
movement for microscopes IRIO?
- Introduce the key on the slice
(edge) of the macrometric
movement and open it.
- Fall saw her(it) central (1)
clockwise.
Attention: this operation is only
made if saw her(it) central is
steel (silvery) and not in brass
(gilt). If saw her(it) is in brass, it
is necessary to turn(return) the
microscope
with
our
(AFTER-SALES SERVICE).
- Around this lived central, there
is a copper-colored slice (2)
provided with 2 small openings. Arm yourselves with a small screwdriver and
with a hammer and tighten slowly this slice clockwise.
- It is then necessary to re-screw saw her(it) central counterclockwise.
14
SAV
Publicité
