Arcam DV78 Manuel page 14

Using the CR-415 remote control
Dims or turns the DV78's display on or off. Turning the display
off generally gives a slight improvement in sound quality.
Pressing DISP once turns the display off; twice dims the
display. To restore the display to full brightness, press
This button enables you to repeat a selected
section from the disc (see page 16).
Press RPT to cycle through the repeat play options.
Fast play and Skip chapter/tracks
Play fast ( ) and Skip (
'Setup' allows you to configure the DV78 for use
in your system. Ensure that no disc is playing and
press to access the 'Setup' menu.
SETUP
Pause ( ), Play ( ) and Stop ( ) (see page 11).
These buttons are described on the next page.
DV78
14
All manuals and user guides at all-guides.com
OPEN
Opens and closes the disc tray
DISP (display)
a
DISP
third time.
OPEN
A–B
DISP
A–B
RPT (repeat)
RPT
) chapters/tracks in both
directions (see page 11).
SETUP
Playback control
AUDIO
Advanced controls
ZOOM
P
MODE
0–9 keypad
This allows direct access to individual tracks on audio CDs. To
select a track, press the corresponding keypad button followed
by OK . For tracks greater than 9, enter the digits in sequence.
For example, to play track 15, press
Standby
DVD
Press
Note that Arcam CD players are not controlled by this button.
CLEAR
1 2 3
Use
a numeric field (see pages 16–17).
4 5 6
PROG (program)
7 8 9
You can program a selection of up to 20 chapters/tracks
from a disc to play in any order. Press
0
CLEAR PROG
'Programme' menu (see pages 17 and 19).
Slow play
Press
backwards. There are four speeds of slow playback: 1/5,
1/4, 1/3 and 1/2. Press the button repeatedly to cycle
through the different speeds. To resume normal playback
speed, press
SETUP MENU
Note that slow play does not apply to audio CDs.
MENU
Press
OK
This navigation menu is specific to a disc and varies for
each title, but typically offers facilities to select chapters,
languages, and view extra material such as trailers or
documentaries.
Once the menu has been accessed, use the cursor pad to
move around the menu and press
'button'.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and
TRIM TITLE RTN menu pages. Confirm your selection with the
MUTE
ANGLE SUBT PL
Stops sound to the speaker outputs of certain Arcam amplifiers.
STATUS MEM SRCH
Volume +/–
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume (+/–) controls and
no effect on the audio output level of the DVD players.
CR-415
NOTE: Remember to install the two AAA batteries supplied
before trying to use your remote control.
Do not place anything in front of the display area on the
DVD player (where the IR receiver is located), or the
remote control may not work.
, then , then .
1 5 OK
to toggle the standby state of the DVD player.
Standby
CLEAR within the 'Program' and 'Bookmark' menus to clear
PROG
or on the remote control to play slow forward or
.
PLAY
to access the DVD 'Disc' menu.
MENU
to activate a menu
OK
to access the
button.
OK
button have
MUTE