Installation Steps - Avs Bugflector Instructions D'installation

Installation Steps

Remove and discard (4) fasteners from hood
weatherstrip noted in Step 2.
3
Peel back 2" (5cm) of tape liner from each
end of hood shield.
5
7
Do not overtighten
8
NOTE: Actual application may vary slightly from drawings.
2" (5 cm)
Install (4) phillips screws with washers as indicated.
hood
hood shield
weatherstrip
washer
phillips screw
Remove tape liner from both outboard flanges.
Clean outboard edges of hood with an
4
Carefully slide (4) inboard hood shield flanges under
weatherstrip and align hood shield with holes in hood.
6
X4
X2
Page 2 of 3
alcohol pad.