Bushnell GOLF TOUR V6 Mode D'emploi page 6

BITE MAGNETIC MOUNT
The Tour V6 features a powerful BITE magnet incorporated into the right side of
its housing, which allows the device to be securely attached to a golf cart bar or
frame. Be sure to attach the rangefinder to the cart frame with the eyepiece at the
one o'clock position. This positioning will ensure the magnet is properly aligned and
engaged with the cart bar.
WARNING: THE BITE FEATURE INCLUDED WITH THE DEVICE CONTAINS A
NEODYMIUM MAGNET. MAGNETS COULD AFFECT THE FUNCTIONING
OF PACEMAKERS AND IMPLANTED HEART DEFIBRILLATORS. IF YOU USE
THESE DEVICES, KEEP A SUFFICIENT DISTANCE FROM THE MAGNET.
ALSO, WARN OTHERS WHO WEAR THESE DEVICES FROM GETTING TOO
CLOSE TO MAGNETS.
• A magnet may permanently lose part of its adhesive force if exposed to
temperatures above 175º F (80º C).
• Magnets produce a far-reaching, strong magnetic field. They could damage
TVs, laptops, computer hard drives, credit and ATM cards, data storage media,
mechanical watches, hearing aids, and speakers. Keep the unit away from
devices and objects that strong magnetic fields could damage.
• Magnets have strong magnetic fields which can pinch skin and fingers. So use
caution when attaching the unit to a metal bar.
CLEANING AND GENERAL CARE
Your Bushnell Tour V6 laser rangefinder lenses are fully multi-coated for the highest light transmission. However, as with
multi-coated optics, take special care to clean the lenses. Follow these tips for proper lens cleaning:
• Blow away any dust or debris on the lens (or use a soft lens brush).
• To remove dirt or fingerprints, clean with the supplied microfiber cloth rubbing in a circular motion. Using a coarse
cloth or unnecessary rubbing may scratch the lens surface and cause permanent damage. The included washable
microfiber cleaning cloth is ideal for cleaning your optics. First, breathe lightly on the lens to provide slight moisture,
then gently rub the lens with the microfiber cloth.
• For a more thorough cleaning, photographic lens tissue and photographic-type lens cleaning fluid or isopropyl alcohol
may be used. Always apply the fluid to the cleaning cloth – never directly on the lens.
• The rangefinder is water resistant but should not be exposed to heavy rain or other direct streams of water and will not
withstand submersion in water or other liquids.
CAUTION: Use caution to avoid direct sunlight into the eyepiece to prevent damage to the display/internal components. When
using the BITE magnet to attach the device to a cart bar or frame, tilt the device so the eyepiece aims towards the ground, not
pointed upwards towards the sun. When you are not using the device, please store it in the case for additional protection.
TROUBLESHOOTING
NEVER DISASSEMBLE YOUR LASER RANGEFINDER. IRREPARABLE DAMAGE CAN RESULT FROM UNAUTHORIZED
SERVICE ATTEMPTS, VOIDING THE WARRANTY.
If the unit does not turn on or the display does not illuminate:
• Depress Power/Fire button.
• Check and, if necessary, replace the battery. If the unit does not respond to button presses, replace the battery with a
good quality CR2 3-volt Lithium battery.
If the unit powers down (the display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a new 3-volt lithium battery (CR2).
If target range cannot be obtained:
• Ensure the display is illuminated.
• Make sure that the Power/Fire button is being depressed.
• Ensure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target) that emit
and receive the laser pulses.
• Make sure the unit holds steady while depressing the Power/Fire button.
NOTE: The last range reading does not need to be cleared before ranging another target. Aim at the new target using the display
reticle, depress the Power/Fire button, and hold until the new range reading is displayed.
6
Click to Return to the Table of Contents
BITE MAGNET
Cart
Frame