Télécharger Imprimer la page

APEX FORGE M8 Mode D'emploi page 7

Publicité

Les langues disponibles

Les langues disponibles

a)
The appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction
b)
Children being supervised not to play with the appliance
c)
Do not recharge non-rechargeable batteries!
d)
During charging, batteries must be placed in the well-ventilated area!
e)
Integrated batteries may only be removed for disposal by qualified personnel. Opening the housing
shell can destroy the power tool. To remove the battery from the power tool, press the On/Off switch
until the battery is fully discharged. Unscrew the screws on the housing and remove the housing shell
in order to remove the battery. To prevent a short circuit, disconnect the connectors on the battery
one at a time and then isolate the poles. Even when fully discharged, the battery still contains a
residual capacity, which can be released in case of a short circuit.
Electrical safety
When using electric machines always observe the safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal injury. Read the following safety instructions and also
the enclosed safety instructions.
TECHNICAL SPECIFICATIONS
Rechargeable battery
Input of charger
Output of charger
Battery charging time
Maximum disc diameter
No load speed
Capacity of spring chuck
Weight
8V Max Li-ion 2000mAh
100-240V~ 50/60Hz 0.2A
9.0V DC 1.0A
2-3hours
5,000–30,000/min
Ø3.2 mm Max.
- 05 -
Ø35 mm
0.38 kg

Publicité

loading