Publicité
Les langues disponibles
Les langues disponibles
d)
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool. Power tools are dangerous in the hands of
untrained users.
e)
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any
other condition that may affect the power tools operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
f)
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g)
Use the power tool, accessories and tool bits, etc. In accordance with these instructions and in the
manner intended for the particular type of power tool, taking into account the working conditions and
the work to be performed. Use of the power tool for operations different from those intended could
result in a hazardous situation.
5)
Service
a)
Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
Safety instructions for all operations
Safety warnings common for grinding, sanding, wire brushing, polishing, carving or abrasive
cutting-off operations:
a)
This power tool is intended to function as a grinder, sander, wire brush, polisher, carving or cut-off
tool. Read all safety warnings, instructions, illustrations and specifications provided with this power
tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious
injury.
NOTE List only those operations that are applicable.
b)
Do not use accessories which are not specifically designed and recommended by the tool manufactur-
er. Just because the accessory can be attached to your power tool, it does not assure safe operation.
c)
The rated speed of the grinding accessories must be at least equal to the maximum speed marked
on the power tool. Grinding accessories running faster than their rated speed can break and fly apart.
d)
The outside diameter and the thickness of your accessory must be within the capacity rating of your
power tool. Incorrectly sized accessories cannot be adequately controlled.
e)
The arbor size of wheels, sanding drums or any other accessory must properly fit the spindle or collet
of the power tool. Accessories that do not match the mounting hardware of the power tool will run out
of balance, vibrate excessively and may cause loss of control.
f)
Mandrel mounted wheels, sanding drums, cutters or other accessories must be fully inserted into the
collet or chuck. If the mandrel is insufficiently held and/or the overhang of the wheel is too long, the
mounted wheel may become loose and be ejected at high velocity.
g)
Do not use a damaged accessory. Please inspect the accessory before each use such as abrasive
wheels for chips and cracks, sanding drum for cracks, tear or excess wear, wire brush for loose or
cracked wires. If power tool or accessory is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory, position yourself and bystanders away from
the plane of the rotating accessory and run the power tool at maximum no-load speed for one minute.
Damaged accessories will normally break apart during this test time.
h)
Wear personal protective equipment. Depending on application, use face shield, safety goggles or
safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and workshop apron
capable of stopping small abrasive or workpiece fragments. The eye protection must be capable of
stopping flying debris generated by various operations. The dust mask or respirator must be capable
of filtrating particles generated by your operation. Prolonged exposure to high-intensity noise may
cause hearing loss.
i)
Keep bystanders a safe distance away from work area. Anyone entering the work area must wear
personal protective equipment. Fragments of workpiece or of a broken accessory may fly away and
cause injury beyond immediate area of operation.
j)
Hold power tool by insulated gripping surfaces only, when performing an operation where the cutting
accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may
- 02 -
Publicité
