Makita LW1400 Manuel D'instruction page 6

► 1. Guide plate 2. Lever
For LW1401
NOTICE:
When performing right miter cut,
always set the guide plate at 0 - 170 mm (0"-
6-11/16") position. Setting at the 35 - 205 mm
(1-3/8"- 8-1/16") or 70 - 240 mm (2-3/4"- 9-7/16")
position hinders the movement of stopper plate,
which results in a failure cut.
Loosen the two hex bolts using a socket wrench. Turn
the guide plate to the desired angle and secure it with
the hex bolts. Be careful not to move the set angle while
securing the hex bolts.
► 1. Guide plate 2. Hex bolts
NOTE: The scale on the guide plate is only a rough
indication. For more accurate angle, use a protractor
or triangle ruler. Keep the handle down so that the
cut-off wheel extends into the base. At the same time,
adjust the angle between the guide plate and the cut-
off wheel with a protractor or triangle ruler.
Stopper plate
1
2
For LW1401 only (country specific)
B
► 1. Stopper plate
The stopper plate prevents the cut-off wheel from
contacting the workbench or floor. When a new cut-off
wheel is installed, set the stopper plate to position (A).
When the cut-off wheel wears down to the extent that
the lower portion of the workpiece is left uncut, set the
stopper plate to position (B) to allow increased cutting
capacity with a worn down wheel.
ASSEMBLY
CAUTION:
1
switched off and unplugged before carrying out
any work on the tool.
Removing or installing cut-off wheel
CAUTION:
2
clamp or hex bolt securely. Insufficient tightening
may result in severe injury. When tightening the hex
bolt, use the socket wrench provided with the tool to
assure proper tightening.
CAUTION:
and outer flanges which are provided with the
tool.
CAUTION:
after replacing the wheel.
6 ENGLISH
1
A
Always be sure that the tool is
Be sure to tighten the toolless
Always use only the proper inner
Always lower the safety guard