Publicité
Les langues disponibles
Les langues disponibles
18
www.aeg.com
12. TROUBLESHOOTING
Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
The loading
door does not
closed
Err (Error) on
the display.
Possible cause
1)
The tumble dryer is not connected
to mains supply.
The loading door is opened.
The On/Off button was not push-
ed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus option was in mini-
4)
mum level.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the humidity sensor in the
drum.
Incorrect remaining laundry mois-
ture degree.
The condenser is clogged.
The filter not locked in the posi-
tion.
The laundry is locked between the
door and the seal.
You try to change the programme
or the option after the start of the
cycle.
The option you try to activate is
not applicable with the selected
programme.
Remedy
Connect in at mains socket. Check
fuse in fuse box (domestic installa-
tion).
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Do the selection of the applicable
2)
programme.
3)
Clean the filter.
Change the Dry Plus option to the
moderate or maximum level.
Obey the maximum load volume.
Clean the airflow grill in the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust remaining laundry moisture
5)
degree.
Clean the condenser.
Put the filter in the correct posi-
tion.
Put the load correctly in the drum.
Turn the tumble dryer off and on.
Make the new selection.
Turn the tumble dryer off and on.
Make the new selection.
4)
3)
Publicité
