AKG C 411 III Mode D'emploi page 14

2 Interfacing
2.1 Introduction
Important!
(
2.2 C 411
III
2.2.1 Connecting
to Balanced
Inputs
Refer to fig. 1.
MPA
Fig. 1: Connecting to a balanced input.
14
The C 411
therefore needs a power supply.
Using any power supply other than those
recommended by AKG may damage your
pickup and will void the warranty.
PP 1. Connect the phantom power adapter (1) on the
pickup cable to a balanced XLR microphone
input with phantom power.
2. Switch the phantom power on. (Refer to the in-
struction manual of the unit to which you
connected your pickup.)
3. If your mixer provides no phantom power:
Connect the phantom power adapter (1) to an
optional AKG phantom power supply (2) (N 62 E,
N 66 E, B 18, B 15) and use an XLR cable (3)
(e.g., an optional MK 9/10 from AKG) to connect
the phantom power supply to the desired
balanced input.
Phantom
pickup is a condenser transducer and
III
MPA