Publicité
Les langues disponibles
Les langues disponibles
24 electrolux
When you connect the appliance to the elec-
trical supply or in case of a power cut, the
Time function indicator flashes automatically.
To set the current time use " + " or " - " but-
ton.
After approximately 5 seconds, the flashing
stops and the display shows the time of
day set.
For time change you must not set an au-
tomatic function (Duration
) at the same time.
Initial Cleaning
• Remove all parts from the appliance.
HOB - DAILY USE
Ignition of the burner
Warning! Be very careful when you
use open fire in kitchen environment.
Manufacturer decline any responsibility
in case misuse of the flame
Always light the burner before you put
cookware.
To light the burner:
1. Push and hold the spark generator but-
ton
.
2. Turn the control knob counterclockwise
to the maximum position
3. Release the spark generator button but
keep the control knob on this position
for approximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
4. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are
in correct positions.
All manuals and user guides at all-guides.com
• Clean the appliance before first use.
Important! Refer to chapter "Care and
Cleaning".
Preheating
Set
an empty oven for 45 minutes, to burn off
any residue from the cavity surface. Acces-
sories can become hotter than in normal
use. During this period an odour can be emit-
or End
ted. This is normal. Make sure the room is
well ventilated.
.
1
2
3
4
Important! You can light the burner
without electrical device (e.g. when there is
no electricity in the kitchen). To do so, put
the flame near the burner, push the related
control knob down and turn it
counterclockwise to the maximum gas
release position.
and maximum temperature and run
Burner cap
Burner crown
Ignition candle
Thermocouple
Warning! If the burner does not light
after 15 seconds, release the control
knob, turn it into off position and try to
light the burner again after minimum 1
minute.
1
2
3
4
Publicité
