Hinkley 27 Bryce Manuel D'instructions page 13

Option 3. Multi Gang Wall Switch Box Installation
1 Remove the existing wall plate and old switch from the wall outlet box. (Fig. 3)
Connect the black lead wires from the switch in the cradle A to the black wires in the switch box. Hot input wire to one of the
2
cradle switch leads. Power lead to the fan is connected to the remaining switch lead. (Fig. 4)
3
Attach the cradle A to the wall switch box using the supplied hardware.
Attach the multi-gang faceplate to the switch set in the wall outlet box. Cradle A of Hinkley switch will fit in any standard d
4
face plate.
5 Remote transmitter will be held in place with built in magnets.
Outlet box
Switch
Fig. 3
HIRO Control System
11
| hinkley.com
Outlet box
Face plate
Fig. 4
Cradle A
Face plate
Transmitter