Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE & CARE
1. Annual Maintenance
In order to reduce freeplay and extend the life of your PowerBase system, it's
important to tighten the breakaway fasteners to the required torque values shown
in Figure F at the beginning and end of the boating season, or at least once a year.
Take care not to over tighten the fasteners, and to tighten specifically to the value
required for your applicable system.
Figure F
LIGHT SYSTEM
2. Manual Position Override
If necessary, your PowerBase's position can be manually adjusted to either the
stowed or deployed position by following the steps shown in Figure G. Take care to
tighten the fasteners to the torque values shown in Figure F.
Figure G
STEP 1: REMOVE COVER
STEP 4: REINSTALL SHEAR PIN
TIGHTEN TO 5.2 FT-LBS
TIGHTEN TO 2.2 FT-LBS
STEP 2: REMOVE SHEAR PIN
ANTENNA SYSTEM
STEP 5: REINSTALL COVER
9
TIGHTEN TO 11 FT-LBS
TIGHTEN TO 2.2 FT-LBS
STEP 3: LINE UP HOLE WITH
BINDING POST HOLE
Publicité
