Publicité
Les langues disponibles
Les langues disponibles
WIRING THE POWERBASE UNIT
a. With at least 18-gauge marine grade wire, route the wires first through the gasket,
and then through the drilled wire-access hole to remove as much slack from above
the mounting surface as possible.
b. Utilize the included wiring diagram (Figure A) to connect the following...
i. 12V SWITCH (Two Position) – Positional Control
ii. PowerBase Light: 12V SWITCH (Three Position) – Navigation Light Control
Figure A- PowerBase Wire Diagram
Recommended Installation:
• Switch A: 2-Position Switch (Backlit)
• Switch B: 3-Position Switch
See Blue Seas Systems Contura II Switches
for compatible switch offering.
12V System
Seal or tie to GND
12V System
Seal or tie to GND
PowerBase Antenna: Seal/Tie to GND: Gray, White, and Brown
2-Pos Switch
Power
SPST
LED
Switch A
(Position Control)
2-Pos Switch
Power
SPST
LED
Switch A
(Position Control)
Wires, while otherwise following Switch A configuration.
3-Pos Switch
DPDT
Switch B
(Light Control)
OR
3-Pos Switch
DPDT
Switch B
(Light Control)
4
Publicité
