Publicité
Les langues disponibles
Les langues disponibles
AFFIX THE POWERBASE UNIT TO
THE MOUNTING SURFACE
a. Prior to securing the unit to the mounting
surface, apply marine-grade sealant on the
mounting surface side of the gasket, as well
as the underside of the PowerBase Unit.
b. With sealant side down, place the gasket on
the mounting surface aligning with the pre-
drilled hole pattern.
c. Install the PowerBase unit overtop of the
gasket, securely fastening with the included
screws and plastic washers. See exploded
view in Figure B.
INSTALL ATTACHMENT TO POWERBASE
a. PowerBase Light
i. Prior to installing the pole to the PowerBase Unit, route the wires coming from the
bottom of the pole through the PowerBase Break Away hole.
ii. Connect the pin connectors to the associated receptacles on the PowerBase wire
harness as shown in Figure C & D.
BLACK WIRE
Figure C - All-Around Light (5590 Series)
RED WIRE
WHITE WIRE
RED WIRE
TO BE PLUGGED
Figure D - Masthead Light (7800 Series)
6
Figure B - PowerBase Mounting
WHITE WIRE
BLACK
WIRE
Publicité
