Publicité
Les langues disponibles
Les langues disponibles
3. SafeGuard Breakaway Shear Pin Replacement
In the event of an impact your PowerBase unit is equipped with SafeGuard
Breakaway feature, helping minimize the damage to the Vessel, PowerBase, and
Light/Antenna. Once SafeGuard Breakaway has been engaged, you'll need to
replace the shear pin with a new Attwood PowerBase Shear Pin (Attwood Part
Number: 6001-7). See Figure H for the steps needed to remove and install your
new shear pin. Take care not to discard the cover fastener during replacement, and
always remember to tighten the fasteners back to the required torque values shown
in Figure F.
Figure H
STEP 1: REMOVE COVER, SHEAR PIN AND BINDING POST.
STEP 2: LINE UP CENTER HOLE
DISCARD BROKEN SHEAR PIN AND BINDING POST.
WITH BINDING POST HOLE
STEP 3: INSTALL NEW SHEAR PIN AND BINDING POST.
RE-INSTALL COVER.
10
Publicité
