Attwood PowerBase 6100 Serie Manuel D'instructions page 2

POWERED FOLD-DOWN LIGHT AND ANTENNA BASE
6100 Series
SAVE THESE INSTRUCTIONS
#21421 Rev A 0322
• Attwood PowerBase Light is compatible with and solely designed for use with
Attwood LightArmor LED All-Round (5590 Series) and LED Masthead Lights
(7800 Series). If replacing a previously installed light, always remember to
replace it with one of at least the same pole length and rated visibility.
• Attwood PowerBase Antenna is compatible with most leading antennas up to
8ft in length that utilize industry standard 1"-14 threading and single mounting
points. Installing an antenna outside of this specification may result in damage to
unit and surroundings.
REQUIRED FOR INSTALLATION:
• 7/32" & 3/4" Drill Bits / Drive Sizes
• #2 Phillips Driver
• Marine Grade Sealant
• PTFE Lubricant
• 2x 1-1/4" Fender Washers and 10-24
Nuts (If Through-Hole Mounting)
PowerBase
IMPORTANT
• 2-Position SPST Switch (with LED Backlight)
• PowerBase Light: LightArmor LED All-Round
(5590 Series) or Masthead/Anchor Light
(7800 Series)
2