JBL ProFlora pH Control Touch Mode D'emploi page 27

Parts and names
1 Mounting bar
2 Screws with wall plugs (2 of each)
3 Universal power unit, secondary with 2 m cable and plug
4 Control device PROFLORA pH Control Touch
5 Coloured touch display
6 Input socket for 12 V DC power supply
7 Connection for temperature sensor
8 BNC connector for pH sensor
9 12 V DC output socket for connecting cable of solenoid valve
10 Temperature sensor
10a Suction pad for temperature sensor (2x)
11 Connecting cable for solenoid valve
12 Tray for calibration cuvettes
13 JBL PROFLORA pH-Sensor +Cal (please purchase separately!)
Installation
The illustration shows a typical installation
1 Measurement and control device JBL PROFLORA pH control Touch
2 Universal power supply
3 pH sensor
4 Temperature sensor
5 CO reactor JBL PROFLORA Taifun
6 Bubble counter with integrated check valve JBL PROFLORA Count safe
7 Connecting cable for solenoid valve
8 Solenoid valve JBL PROFLORA v002
9 CO special hose
Mounting the JBL PROFLORA pH Control Touch measurement and control device
First attach the mounting bar in a horizontal position to the desired position on the wall near
the aquarium, using the two screws supplied.
Then line up the mount at the back of the device with the top edge of the bar and, by
pushing the front gently, click the device into place. (It can be easily taken o the mounting
bar at any time by sliding it out laterally.)
Installing the sensors and connecting to the power supply
Connect the plug of the pH sensor and the temperature sensor with the corresponding
connections on the appliance. Do not install the two sensors in the aquarium until
calibration has been carried out. Connect the JBL PROFLORA v002 solenoid valve provided
to the pH control device using its connecting cable. The connection on the device is marked
with "valve". Any previous power supply unit for the solenoid valve is no longer required. All
connectors and plugs on the device as well as on the sensors and cables are con gured in
such a way that an incorrect connection is not possible.
Plug the universal power supply unit into a nearby power socket and insert the plug on the
cable into the socket labelled 12 DC on the device.
DE
UK
FR
NL
IT
ES
PT
SE
CZ
PL
RU
RO
TR
23