VONROC LM507XX Traduction De La Notice Originale page 7

Model No.
Cutting width
No. of Cylinder Blades
Cutting height
Grass box capacity
Weight
Model No.
Cutting width
No. of Cylinder Blades
Cutting height
Grass box capacity
Weight
DESCRIPTION
1. Upper handle
2. Middle handle bar
3. Lower handle
4. Mower
5. Grass catcher
6. Knob
7. Bolt
8. Wall bracket with screws
9. Spring-loaded pin
10. Counterblade adjustment nut
11. Blade
12. Counterblade
13. Roller
14. Belt buckle
3. ASSEMBLY
Study each figure and identify the components
required with reference to the figure 'package
contents' and the contents table above.
Attaching the handle (Fig. A, B, C, E)
1. Attach lower handle (3) to the mower (4). First
attach one side of the handle and gently push
the other hole of the lower handle onto the
notch on the mower, as shown on figure A.
2. Mount the middle handle bars (2) to the upper
handle (1), using the bolts (7) and knobs (6), as
shown on figure B.
3. Now mount the assembled upper and middle
handle onto the lower handle, using the bolts
(7) and knobs (6), as shown on figure C.
WWW.VONROC.COM
LM507XX
300 mm
5
15-25-31-35 mm
14 L
6.0 kg
LM508XX
400 mm
5
15-25-31-35 mm
18 L
6.9 kg
4. A properly assembled lawn mower can be seen
on figure E.
Assembling the grass catcher
1. Ensure the metal bar frame is pre-assembled
properly into the grass catcher (5).
2. Snap the plastic clamps on the side of the grass
catcher (5) onto the side bars of the metal frame.
3. Snap the plastic clamps on the bottom of the
grass catcher (5) onto the lower bar of the
metal frame.
Attaching the grass catcher to the lawn mower
(Fig. D)
1. Attach the assembled grass catcher (5) to the
roller (13), as shown on figure D.
2. Secure the grass catcher (5) to the mower
by attaching the belt buckle (14) to the lower
handle bar (3), as shown on figure D.
4. OPERATION
Adjusting the cutting height (Fig. F)
The cutting height can be set on respectively 15-
25-31-35 mm height. To adjust the cutting height:
1. Pull the spring-loaded pins (9) outwards on
both sides of the mower (4).
2. Adjust to the desired cutting height, which is
indicated on the mower.
3. Now release the spring-loaded pins (9), ensuring
that they are properly seated into the destined
holes in the mower housing. Note: both sides
must always be set to the same height.
Re-adjusting the blade mechanism (Fig. G)
Always wear gloves when handling or
working near the sharp blades.
The cutting mechanism is carefully adjusted at
the factory. Readjustment might be required, for
example after prolonged use. Only readjust if one
or more of the following conditions are met:
• The cutting results appear rough and uneven
and some blades of grass are not cut (the
distance between the counter blade and mower
spindle is too large);
• Heavy resistance when pushing the mower or
even impossible to push;
• The mower blade mechanism makes loud
noises or does not rotate because it rubs or
catches against the counter blade.
EN
7