Fimer T 422 Manuel D'emploi page 39

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

3. Once the password has been confirmed
the display will show the message in Fig. C,
a lock symbol in the area 1 of the display and
the functions Unlock
(reset password) which correspond to
buttons 2 and 3 (fig. 1) respectively, in area
2 of the display;
4. To exit the lock option of the work
stage, briefly press switch 8 in fig. 1;
5. Should the need to modify the work
stage arise, activate the 'Unlock'
by pressing the function button. The
unlock function will require the user to
enter the password that was set and
activated as described above.
6. The reset password option can be
activated by pressing the
button.
WARNING:
The Reset Password option should
only be used when there is no way of
tracing the work stage and when the
Lock/Unlock password has been lost.
To
use
this
function
constructor
technical
department directly.
and Reset pw
option
(Reset pw)
contact
the
support
Appendix:
titles/button symbols/function buttons
and pop-up notifications
In the following figure and table, you will find
the descriptions of the principal title/button
symbols/function
buttons
notifications, with regard to error messages
that may appear on the display:
Position
Symbol
on
display
F4 key
F3 key
F1 key
F1 key
F1 key
and
pop-up
Tasto F1
Tasto F2
Tasto F3
Tasto F4
Description
If information needs to be
entered by the user, this
button must be pressed to
confirm the data
Press this button in the
event user data is requi-
red and you need to can-
cel the operation;
In the event there is a
request for the user to
enter data, use this but-
ton to cancel the last digit
entered;
When the keyboard lock
function is activated, using
switch 10 (fig.1), this but-
ton must be pressed to
deactivate the lock.
When the keyboard lock
function
is
activated,
using switch 10 (fig.1),
this button must be pres-
sed to activate the lock.
15

Publicité

Table des Matières
loading

Table des Matières