JVC GR-AX1010 Manuel D'instructions page 53

CAUTIONS
DANGER:
Video Light
• The video light becomes extremely hot. Do not
• Do not place the camcorder into the carrying case
• When operating, keep a distance of about 30 cm
• Do not use near flammable or explosive materials.
When using the AC Power Adapter/Charger
in areas other than the USA
USING HOUSEHOLD AC PLUG ADAPTER
In case of connecting the unit's power cord to an
AC wall outlet other than American National
Standard C73 series type use an AC plug adapter,
called a "Siemens Plug", as shown.
For this AC plug adapter, consult your nearest JVC
dealer.
General Battery Precautions
• When the C-P6U or C-P7U (cassette adapter) are
• Use only the following batteries:
Please make note of the following rules for battery
use. When misused, batteries can leak or explode.
1. Refer to the C-P6U/C-P7U instructions when
2. Do not use old and new batteries together.
3. Do not use two different kinds of batteries.
4. Do not expose batteries to excessive heat as they
5. Do not dispose of batteries in a fire.
6. Remove batteries from the unit if it is to be stored
Downloaded from: https://www.usersmanualguide.com/
touch it either while in operation or soon after
turning it off, otherwise serious injury may result.
immediately after using the video light, since it
remains extremely hot.
(1 ft.) between the video light and people or
object.
The provided AC Power Adapter/Charger features
automatic voltage selection in the AC range from
110 V to 240 V.
Plug adapter
not functioning even when correctly operated, the
batteries are exhausted. Replace them with fresh
ones.
C-P6U or C-P7U..................... AA (R6) size
replacing batteries.
Although sizes may be the same, voltages may
differ.
can leak or explode.
for an extended period to avoid battery leakage
which can cause malfunctions.
Battery Packs
The supplied battery pack is a
nickel-cadmium battery. Before using
the supplied battery pack or an
optional battery pack, be sure to read
the following cautions:
1. To avoid hazard . . .
.... do not burn.
.... do not short-circuit the terminals.
.... do not modify or disassemble.
.... use only specified chargers.
2. To prevent damage and prolong service
life . . .
.... do not subject to unnecessary shock.
.... avoid repeated charging without fully
discharging.
.... charge in an environment where
temperatures are within the tolerances shown
in the chart below. This is a chemical
reaction type battery—cooler temperatures
impede chemical reaction, while warmer
temperatures can prevent complete charging.
.... store in a cool, dry place. Extended exposure
to high temperatures will increase natural
discharge and shorten service life.
.... avoid prolonged uncharged storage.
.... remove from charger or powered unit when
not in use, as some machines use current
even when switched off.
3. To prevent damage to the camcorder . . .
.... replace the battery pack when it begins to
deliver less recording time per charge.
NOTE:
It is normal for the battery pack to be warm after
charging, or after use.
Temperature Range Specifications
Charging .................... 10°C to 35°C (50°F to 95°F)
Operation .................. 0°C to 40°C (32°F to 104°F)
Storage ....................... –10°C to 30°C (14°F to 86°F)
NOTES:
● Recharging time is based on room temperature of
20°C (68°F).
● The lower the temperature, the longer recharging
takes.
53
EN
Terminals