JVC GR-AX1010 Manuel D'instructions page 29

B
Fades in/out to a black screen.
Fades in/out to a blue screen.
Gradually turns/returns the picture into/from a
mosaic pattern.
A black screen moves in from the top and bottom,
closing over the image like a shutter, or a new
image pushes open the black screen vertically from
the center. *During Auto Select mode, the new
image wipes in over the old image, not a black
screen.
A black screen moves in from the left to gradually
cover the image, or a new image moves in from
right to left. *During Auto Select mode, the new
image wipes in over the old image, not a black
screen.
A black screen starts in the lower left corner and
gradually fills the screen, or a new image starts in
the upper right corner and fills the black screen.
*During Auto Select mode, the new image wipes in
over the old image, not a black screen.
1
2
3
SCROLL WIPE (AUTO SELECT only)
A new image scrolls up onto the screen.
WINDOW WIPE (AUTO SELECT only)
A new image enters from the center and moves
towards the corners of the screen.
DOOR WIPE (AUTO SELECT only)
A new image opens like a door onto the screen.
Downloaded from: https://www.usersmanualguide.com/
K
BLACK FADER
C
BLUE FADER
MOSAIC FADER
SHUTTER WIPE
SLIDE WIPE
CORNER WIPE
DISSOLVE
Press the RECORDING START/STOP button.
— Recording starts.
Press the RECORDING START/STOP button
again.
— Recording stops, and the Record–Standby
mode is engaged.
— Now the last scene is stored in memory.
Before the power turns off...
Press the RECORDING START/STOP button to
resume recording.
— The stored scene is gradually replaced by the
new scene being shot.
— —
AUTO SELECT
Press RECORDING START/STOP to begin or end
recording, and 6 wipe-ins are automatically
generated, in the order shown below:
SLIDE WIPE
SCROLL WIPE
CORNER WIPE
WINDOW WIPE
DOOR WIPE
SHUTTER WIPE
1
Press the RECORDING START/STOP button.
— Recording starts.
2
Press the RECORDING START/STOP button
again.
— Recording stops and the Record-Standby
mode is engaged.
— Now the last scene is stored in memory.
Before the power turns off...
3
Press the RECORDING START/STOP button to
resume recording.
— The new scene gradually wipes in over the
stored scene.
— Repeat steps 2 and 3 as you like.
NOTES
(for Dissolve and Auto Select):
● Turning off the camcorder will erase the scene
stored in memory. When a scene is erased from
memory, the symbol indication blinks.
● The sound for the last recording's scene is not
stored in memory.
● This mode indicator blinks unless an image is
stored in memory. In this case, shoot a scene first.
29
EN