Publicité
Les langues disponibles
Les langues disponibles
42
IN/OUT
Downloaded from:
https://www.usersmanualguide.com/
EN
REW/FF
CANCEL
IN/OUT
R.A. EDIT
PLAY/PAUSE
STOP
To JLIP
To AUDIO and
VIDEO out
connectors
Editing cable
Audio and Video
(provided)
cable (optional)
A
C
B
To Remote
To AUDIO and
PAUSE
VIDEO IN
connectors
To Pause-In
VCR (Recording deck)
CANCEL
RM-V706U
(provided)
ON/OFF
VCR REC STBY
IN
OUT
IN
1
0:00:25
-- :-- : --
1
0:00:25
2
2
0:03:18
3
3
0:02:33
4
4
0:04:11
5
5
6
6
7
7
8
8
COUNTER
0:00:25
COUNTER
TOTAL
0:00:00
TOTAL
PREPARE CAMCORDER
2
Insert a recorded tape and set the Power switch to
"PLAY".
PREPARE VCR
3
Turn the power on, insert a recordable tape and
engage the AUX mode (refer to VCR's instructions).
SELECT SCENES
ACCESS R.A. EDIT COUNTER
DISPLAY
1
Press PLAY/PAUSE, then press R.A. EDIT and the
counter display appears in the viewfinder and the
screen of the connected TV.
REGISTER BEGINNING OF SCENE
2
Press REW or FF to locate the beginning of a scene
you want, then press IN/OUT to register that point.
The data appears under IN on the display.
REGISTER END OF SCENE
3
Press REW or FF to locate the end of the scene and
press IN/OUT to register it. The data appears under
OUT on the display. The total time of the registered
scene(s) is displayed at the bottom of the screen.
REGISTER ADDITIONAL SCENES
4
Repeat steps 2 and 3 for each additional scene
(as many as 8).
MAKE CORRECTIONS
5
Press CANCEL during steps 2 and 3 to erase the
most recently registered point.
NOTES:
● The RM-V706U can be used to operate other camcorder
functions as well. Point the RM-V706U at the camcorder's
remote sensor and press any of the following buttons
(function apears in parentheses):
— ON/OFF (camcorder R.A. EDIT)
— IN/OUT (camcorder IN/OUT)
— CANCEL (camcorder CANCEL)
OUT
● There must be at least one second between an in-point and
0:01:05
0:03:31
its corresponding out-point.
0:02:53
-- :-- : --
● To ensure correct operation, leave at least 15 seconds open
between scenes.
● Blank portions of tape cannot be registered as in-points or
0:04:11
out-points.
0:01:13
● If it takes more than 5 minutes to search for an in-point, the
VCR's Record-Pause mode is cancelled and editing doesn't
take place.
● Pressing R.A.EDIT clears all in- and out-points from
memory.
● Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
EDITING
(cont.)
Publicité
