Inspections - Wittur Servogearless WSG-S2.3 Instructions De Service

Maintenance and repair
7.2

Inspections

To ensure safe and trouble-free operations, the spring-applied brakes must be checked at regular intervals
and, if necessary, replaced. Servicing will be easier at the plant if the brakes are made accessible. This must
be considered when installing the drives in the plant.
Primarily, the required maintenance intervals for industrial brakes result from their load during operation.
When calculating the maintenance interval, all causes for wear must be taken into account,
brakes with low loads (such as holding brakes with emergency stop function), we recommend a regular in-
spection at a fixed time interval. To reduce costs, the inspection can be carried out along with other regular
maintenance work in the plant.
Failures, production losses or damage to the system may occur when the brakes are not serviced. Therefore,
a maintenance strategy that is adapted to the particular operating conditions and brake loads must be de-
fined for every application. For the spring-applied brakes, the maintenance intervals and maintenance oper-
ations listed in the table below must be followed. The maintenance operations must be carried out as
described in the detailed descriptions.
7.2.1 Maintenance intervals
Type
BFK464
S/S.1/S.2
INTORQ | BA 14.0197 | 04/2016
for service brakes:
❚ according to service life cal-
-
culation
❚ or else every six months
❚ after 4000 operating hours
at the latest
Inspections with assembled brake:
❚ Check release function and
control
❚ Measure the air gap (adjust
if required)
❚ Measure the rotor thickness
(replace rotor if required)
❚ Check for thermal damage
of the armature plates or
flange (dark-blue
tarnishing)
Time interval
for holding brakes with emergency stop:
❚ at least every two years
❚ after 1 m cycles at the latest
Maintenance
Inspections after the brake has been
removed:
❚ Check the play of the rotor
43
toothing (replace worn-out ro-
tors)
❚ Check for breaking out of the
26
torque support at the sleeve
bolts and the armature plate
❚ Check the springs for damage
43
❚ Check the armature plate and
flange or bearing shield
- Levelness < 0.1 mm
- Max. run-in depth = rated
air gap for the size
40. For
43
41