Accessories; Recommended Cutting Equipment - RedMax GZ381 Manuel D'utilisation

Saw chain speed at 133% of maximum engine power
speed, ft/s / m/s.

Recommended cutting equipment

A specific chainsaw model has to be evaluated with the
cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw model RedMax GZ381 met the safety
requirements in ANSI B175.1-2012 and Canadian
Standards Association CSA Z62.1-15 (Chainsaws) and
CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
Note:
Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
Guide bar
Length, in. Pitch, in.
16 0.325
18
Pixel
Pixel is a guide bar and saw chain combination that is
more light weight and designated to offer more energy
efficient use by cutting narrow cuts. Both guide bar and
saw chain need to be Pixel to get these benefits. Pixel
cutting equipment is marked with this symbol.
(Fig. 144)
Filing equipment and filing angles
Using RedMax file gauge will give you the correct filing
angles. We recommend you to always use a RedMax
1284 - 004 - 21.06.2021

Accessories

Gauge, in. Max. nose ra-
dius
0.050 10T
RedMaxGZ381
75.5/23.0
We recommend only to use the listed guide bar and saw
chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012 and CSA Z62.3-11 (R2016).
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is defined by the
number of teeth (for example 10T). For solid guide bars
the nose radius is defined by the size of the nose radius.
For a given guide bar length, you may use a guide bar
with smaller nose radius than listed.
Saw chain
Type
RedMax H30
file gauge to restore the sharpness of the saw chain.
The part numbers are given in the table below.
If you are not sure of how to identify what saw chain you
have on your chainsaw, please visit www.redmax.com
for more information.
Length, drive Low Kickback
links (no.)
66 Yes
72
39