Operation; Putting On The Upper Arm Pressure Cuff; Correct Position For Taking Readings - Medisana CardioDock Mode D'emploi

Module de mesure de tension
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 76

5.1 Putting on the upper arm pressure cuff

First attach the free end of the cuff's air tube to the
designated connector
Slip the preformed cuff over the bare left upper arm.
Position the air hose in
the middle of your arm
in line with your middle
finger (ill.1 a). The lower
edge of the cuff should
be 1 - 2 cm above the
crease of the elbow (ill.1
b). Pull the cuff tight and close the Velcro fastener
(ill.1 c).
Only position the cuff on the right arm if it cannot be
used on the left arm. Always carry out measure-
ments on the same arm.

5.2 Correct position for taking readings

If possible, take the reading while seated.
Relax your arm and place it comfortably, on a table
for instance. Keep still during the measurement: Do
not move and do not talk as this may alter the mea-
surements. The correct measuring position when
sitting is shown in ill.2.
In special cases the measurement can also be
taken when lying down. The correct measuring po-
sition when lying down is shown in ill.3.
The cuff should always be at the same height as
your heart.
6
on the unit.
Ill.1
Ill.2
Ill.3

5 Operation

b
1-2 cm
a
c
G
G
G
G
G
G
21
GB

Publicité

Table des Matières
loading

Table des Matières