Cleaning And Maintenance; Important - cecotec ForceTitanium 720 Smart Manuel D'instructions

ENGLISH
3. The auto-power off light indicator will remain on and the iron will be ready for use.
How to use the water spray
Before using the spray function, check the fabric label for ironing instructions, as some fabrics
may be spotted or stained with moisture. The spray function is particularly helpful to remove
stubborn wrinkles and whenever extra moisture is needed. The spray may be used both with
steam or dry ironing. Simply press the spray mist button when desired.
Ho to use the burst of steam
The burst of steam feature provides additional steam to remove stubborn wrinkles. It may
be used both with steam or dry ironing. Press the burst of steam button to release a burst of
steam that can penetrate the fabric. Pressing the button several times may be necessary to
build up the burst of steam. Wait a few seconds for the steam to penetrate the fabric before
pressing the button again for more steam. You can also use the burst of steam to iron textiles
vertically (curtains, hung clothes, etc.).
Note: for optimal results, do not apply more than three successive bursts after the LCD panel starts flashing.
After use
1. Turn off and unplug the iron.
2. Empty the iron immediately after use. Do not store the iron with water in its tank.
3. Wait until the iron has cooled down before storing it. Let it rest on its base in vertical position
to protect the soleplate from scratches, corrosion, or stains.

5. CLEANING AND MAINTENANCE

Outside surface of the iron:
After unplugging and letting the iron cool down, wipe its exterior surface with a damp cloth
and, if necessary, a mild detergent.
WARNING: do not use any abrasive cleaning agent.
Soleplate:
Starch and other types of residue may be easily removed from the soleplate with a damp cloth.
To avoid scratches on its finish, do not use metallic scouring pads to clean the soleplate and
never place the iron on a rough surface. If synthetic fabrics are ironed at high temperature, both
the fabric and the soleplate of the iron could be damaged. The best way to remove synthetic
residue from the soleplate is to heat it up and iron over an old cotton rag.
CAUTION: do not use steam iron cleaners in this iron, since they could damage its working parts.
Self-Cleaning:
IMPORTANT: your iron will give the best ironing results and last longer if you use the self-
cleaning function once a month, or more depending upon usage.
1. Fill half of the water tank with water and leave the steam selector in "0FF" position.
2. Place the iron in vertical position.
3. Plug the iron.
4. Set the temperature in the highest setting.
5. Allow the iron to heat up until the LCD panel stops flashing.
6. Unplug the iron from the mains supply and keep it in horizontal position over the sink.
7. Hold the "Autoclean" button until all the boiling water, steam, and impurities come out.
17
FORCETITANIUM 720 SMART
05027_ForceTitanium 720 Smart_Manual_BM.indd 17 13/11/17 8:57