CANARMNA CALMAR Instructions D'installation

SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. NOT FOR USE IN LUMINAIRES CONTROLLED BY A DIMMER.
5. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH
A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Mounting
Bracket
Screw
Fixture
Electrical
Box
Mounting
Bracket
Electrical Box Screws
(not included)
LED OUTDOOR
LIGHTING
1.
Remove the mounting
bracket from the fixture by
unscrewing the 2 screws.
2.
Mount the mounting
bracket to electrica l box using
electrica box screws (not
l
included).
Tel: (613) 342-5424, Fax: (800) 263-4598
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Pliers
Black
White
House
supply
Ground
wire
Fixture
Ground wire
Weather Resistant
Caulking
(not included)
Screw
LOL521
10/20
Wiring supplies
Wire Cutters
as required by
local electrical
code
Wrench
3.
Connect the ground wires
(bare copper or green) from
your fixture to the ground wire
(bare copper or green) or
ground screw in the electrical
box. Attach the black wire from
the light fixture to the black
wire in the electrical box.
Attach the white wire from the
light fixture to the white wire in
the electrical box.
NOTE: Do not disconnect any
pre-wired connections.
4.
Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no
bare wire (on the black and
white) is visible at the wire nuts.
5.
Re-tighten the two screws
to install the fixture.
6.
After Installation, seal
around the top and side
perimeter between the fixture
and the wall surface with
weather resistant caulking. The
bottom should be left
un-caulked to prevent
moisture build-up. Apply a
small amount of weather
resistant caulking around the
side perimeter between the
screw and mounting plate.