CANARMNA EASY CONNECT Serie Mode D'installation

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
!
SAVE THESE INSTRUCTIONS
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. WIRING SUPPLIES AS REQUIRED BY LOCAL ELECTRICAL CODE.
3. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY
A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH
A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Electrical box screws
Easy Connect TM
mounting
bracket
Electrical
Box
White
(Neutral)
Black (Live) Green (Ground)
Option 1
Green
(Ground)
Option 2
Jumper Wire
Jumper
Wire
Black (Live)
Green
Jumper Wire
(Ground)
EASY CONNECT
INSTALLATION INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
1.
Attach Easy Connect™
mounting bracket to electrical
box with electrical box screws
(not included).
2.
Option 1: Connect (push)
electrical wires from electric box
(house wiring) into correct
(N)
inserts.
White
(Neutral)
(L)
Black
(Live)
Option 2: For multiple green
(ground), black (live) and
white (neutral) wires joined in
(N)
the electrical box (house wiring),
White
attach a single "green" , "black"
(Neutral)
and "white" jumper wire before
connecting. Strip 7mm from the
(L)
6" jumper wires supplied. Then
connect (push) wires into the
correct inserts.
Tel: (613) 342-5424, Fax: (800) 263-4598
TM
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
(N) (L)
Black (Live)
White
(Neutral)
Green
(Ground)
Star
Washer
Cap
Nut
Stud
Weather
Resistant
Caulking
(not included)
Cap
Nut
Bulb
IOL456
09/19
3.
Connect (push) electrical
wires from fixture into correct
inserts.
4.
Tuck electrical wires into
electrical box and position
fixture over studs on mounting
bracket assembly. Secure
fixture in place with star
washers and cap nuts.
5.
Install proper bulb type
and wattage (not included).
6.
After installation, seal
around the top and side
perimeter between the fixture
and the wall surface with
weather resistant caulking. The
bottom should be left
un-caulked to prevent moisture
build-up. Apply a small amount
of weather resistant caulking
around the side perimeter
between the cap nut and
mounting plate.