CANARMNA EASY CONNECT IOL444 Mode D'installation

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
!
SAVE THESE INSTRUCTIONS
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. WIRING SUPPLIES AS REQUIRED BY LOCAL ELECTRICAL CODE.
3. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY
A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH
A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Electrical box screws
Easy Connect
mounting
bracket
Electrical
Box
White
(Neutral)
Black (Live) Green (Ground)
Option 1
(Neutral)
Green
(Ground)
Option 2
Jumper Wire
(Neutral)
(L)
Black (Live)
Green
Jumper Wire
(Ground)
(L)
Black (Live)
(N)
White
(Neutral)
Green
(Ground)
EASY CONNECT®
INSTALLATION INSTRUCTIONS
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
1.
Attach easy connect
mounting bracket to electrical
box with electrical box screws
(not included).
2.
Option 1: Connect (push)
electrical wires from electric box
(house wiring) into correct
(N)
White inserts.
(L)
Black
(Live)
Option 2: For multiple green
(ground), black (live) and
white (neutral) wires joined in
(N)
White
the electrical box (house wiring),
attach a single "green" , "black"
and "white" jumper wire before
connecting. Strip 7mm from the
6" jumper wires (AWG 12-24)
supplied. Then connect (push)
wires into the correct inserts.
3.
Connect (push) electrical
wires from fixture into correct
inserts.
Tel: (613) 342-5424, Fax: (800) 263-4598
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Cap 4.
Stud
Nut
electrical box and position
fixture over studs on mounting
bracket assembly. Secure
fixture in place with star
washers and cap nuts.
Star
Washer
5.
and wattage (not included).
Thumb Screw
6.
the fixture using the thumb
Bulb
screws (tighten with fingers
only).
Weather Resistant
7.
Caulking
(not included)
around the top and side
perimeter between the fixture
and the wall surface with
weather resistant caulking. The
bottom should be left
un-caulked to prevent moisture
build-up. Apply a small amount
of weather resistant caulking
Cap
around the side perimeter
Nut
between the cap nut and
mounting plate.
IOL444
03/19
Tuck electrical wires into
Install proper bulb type
Attach the glass shade to
After installation, seal