The Sliding Upper Fence Section; Operating Instructions - Evolution Rage3-Db Serie Traduction D'original

www.evolutionpowertools.com
• When cutting is complete re-adjust the depth stop so that
the Cutting Head can be locked in the down position by the
head latching pin.

THE SLIDING UPPER FENCE SECTION

The Left Hand and Right Hand sides of the Fence have an
adjustable upper section. Adjustment may be necessary to
provide clearance for the moving Cutting Head when acute
bevel or compound angles are selected.
To adjust the Fence:
• Loosen the relevant thumbscrew. (Fig. 9)
• Slide the upper section of the Fence to the required position
and tighten the thumbscrew.
• Conduct a 'dry run' with the power off to confirm that there
is no interference between moving parts as the Cutting
Head is lowered.

OPERATING INSTRUCTIONS

CAUTION: The Mitre Saw should be inspected (particularly
for the correct functioning of the safety guards) before each
use. Do not connect the saw to the power supply until a safety
inspection has been carried out.
Ensure that the operator is adequately trained in the use,
adjustment and maintenance of the machine, before
connecting to the power supply and operating the saw.
WARNING: To reduce the risk of injury, always unplug the saw
before changing or adjusting any of the machines parts. Compare
the direction of the rotation arrow on the guard to the direction
arrow on the blade. The blade teeth should always point downward
at the front of the saw. Check the tightness of the arbor screw.
Fig. 9
21
EN
ES
FR