Setting The Operating Temperature; Prior To Startup - Beko CHE 46260 Notice D'utilisation

en
To avoid accidental water dispensing, we
recommend you lock the water dispenser.
Water tray (Fig. 10)
Water that drips while using the water
dispenser accumulates in the drip tray.
Remove the drip tray by pulling it towards
yourself and empty it from time to time.
Remove the plastic drainer part as shown in
the diagram by pressing down on the edge.
(Fig. 11)
Remove the water valve from the water tank
as shown in the diagram. When re-fitting, make
sure the O-shaped seal is in place. (Fig. 12)
Ice-matic (Fig. 13-14)
Fill the ice-matics with water and put them in
place. Your ice will be ready in about two hours.
It is not necessary to remove the ice-matic In
order to obtain ice; just turn it 90° to the right,
and the ice will drop into the ice-bowl below.
Then take out the ice-bowl to serve the ice. If
you wish, you can leave the ice in the bowl for
a while.
Attention!
The ice-bowl is only meant for collecting ice.
If you put water in, it will break.

Prior to startup

Before you begin operating your device, the
following points should be re-checked for
safety:
• Is the device standing properly on the floor?
• Is there sufficient space for good air
circulation?
• Is the interior clean? (Also see the section
"Cleaning and care")
• Set the thermostat knob half way between
1 and 5 or Min. and Max.
• Now connect the device to the mains.
The compressor is turned on; the interior light
comes on when the door is opened.
Do not place foodstuff into the refrigerator until
the temperature has reached the desired level.
Setting the operating
temperature
(Fig. 2)
The operating temperature is regulated by the
temperature control.
Warm
1
(Or) Min.
1 = Lowest cooling setting (Warmest setting)
5 = Highest cooling setting (Coldest setting)
(Or)
Min. = Lowest cooling setting
(Warmest setting)
Max. = Highest cooling setting
(Coldest setting)
The average temperature inside the fridge
should be around +5°C.
Please choose the setting according to the
desired temperature.
You can stop operation of your device by
adjusting the thermostat knob to "0" position.
Please note that there will be different
temperatures in the cooling area.
The coldest region is immediately above the
vegetable compartment.
The interior temperature also depends on
ambient temperature, the frequency with which
the door is opened and the amount of foods
kept inside.
Frequently opening the door causes the interior
temperature to rise.
For this reason, it is recommended the door
is closed as soon as possible after use.
4 4
2 3 4 5
Max.
en
Cold