Waeco ECW-012VS Instructions De Montage Et De Service page 28

_ECW-012VS.book Seite 28 Montag, 15. Februar 2010 4:20 16
Using the inverter
➤ Insert the cable ends of the remote control into the appropriate connec-
tion:
– Dometic B2200 and Dometic CA2500: cable (15) into connection (13)
– Dometic B1600: cable (16) into connection (14)
9 Using the inverter
Caution!
e
If the inverter is connected to the external mains voltage, the 230 V
output socket is earthed.
If there is no external mains voltage, the inverter is only connected
to the battery (DC operation). In this case, the output socket is not
earthed for 230 V and only by the protective insulation.
Note
I
Refer to the operating instructions of the roof air conditioner and the
remote control which are also included in the scope of delivery.
You do not need to make any settings when using the inverter. All settings
can be made on the roof air conditioner or using the remote control.
However, please note the following:
If the battery voltage drops to below 11 V during operation, a warning sig-
nal sounds and the red error LED (fig. 1 2, page 3) lights up.
If the battery voltage drops to below 10.5 V, the inverter switches off.
If the inverter overheats, it switches off – the red error LED (fig. 1 2,
page 3) lights up.
If this happens, switch the inverter off.
When it cools down, you can use the inverter again.
When operating the inverter at a high load for lengthy periods, it is advis-
able to start the engine in order to recharge the vehicle battery.
You can operate the inverter with the engine running or switched off. How-
ever, do not start the engine while the inverter is switched on, since the
power supply to the cigarette lighter is disconnected during ignition.
28
ECW-012VS