Waeco ECW-012VS Instructions De Montage Et De Service page 27

_ECW-012VS.book Seite 27 Montag, 15. Februar 2010 4:20 16
ECW-012VS
Danger of electric shock
e
Do not connect the connection cable to the battery terminals yet.
➤ Check the connections are secure.
You might have to tighten the screws again later.
Connecting the inverter to the 230 V mains supply
➤ Insert the insulated connection cable (8) included in the scope of supply
in the DC kit into the 230 V power supply of the inverter (9).
➤ Connect the insulated connection cable (8) to the 230 V socket (10) in the
caravan.
Connecting the roof air conditioner to the inverter
Note
I
Refer to the ECL-75, ECL-102 operating manual supplied with the
roof air conditioner for connecting the ECL-102 charging current
distributor.
➤ Insert the 230 V plug on the roof air conditioner (11) into the 230 V output
on the inverter (12).
Connecting the battery
➤ Connect the positive red cable to the positive terminal on the battery.
➤ Connect the negative black cable to the negative terminal on the battery.
Connecting the remote control to the inverter
The inverter has two connections for remote controls which can be used for
the following roof air conditioners:
Remote control 1 (13): Dometic B2200 and Dometic CA2500
Remote control 2 (14): Dometic B1600
Caution!
e
Only use the remote control connections intended for your roof air
conditioner.
➤ Switch off the inverter.
Connecting the inverter
27