Waeco ECW-012VS Instructions De Montage Et De Service page 24

_ECW-012VS.book Seite 24 Montag, 15. Februar 2010 4:20 16
Fastening the inverter
6.2 Fault indication
Fault indication
Low voltage
High voltage
Overloading
Excess temperature The inverter is too hot.
7 Fastening the inverter
Note the following safety instructions during installation:
Ensure the device is standing firmly.
a
Set up the device securely and fasten it in such a way that it can-
not tip over or fall down.
Take precautions necessary to ensure that is out of reach of
children. Dangerous situations may occur which cannot be rec-
ognised by children!
Fasten the device making sure that it is not able to fall down, tip
over or move while the vehicle is in motion.
24
Possible cause
The remaining battery capacity is
too weak.
The input voltage is too high.
The roof air conditioner is con-
suming too much power.
The constant load is too high
under the given circumstances.
ECW-012VS
Suggested remedy
Charge the battery.
Check the input voltage on the
inverter and compare it with the
technical data for the inverter.
Switch off the roof air conditioner
and check the power
consumption.
Check the ventilation.
Switch off the roof air conditioner
and let the inverter cool down.