AEG BBB8002QB Notice D'utilisation page 107

Problems with Wi-Fi signal
Possible cause
The wireless network signal is weak.
The wireless signal is disrupted by another mi‐
crowave oven placed near the appliance.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F240, F439 - the touch fields on the display do
not work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the appliance system cannot connect
with the control panel.
When one of these error messages continues to appear on the display, it means a faulty
subsystem may have been disabled. In such a case contact your dealer or an Authorized
Service Centre. If one of these errors occurs, the rest of the appliance functions will continue to
work as usually.
Code and description
F131 - the temperature of magnetron sensor is
too high.
TROUBLESHOOTING
Remedy
Move router as close to the appliance as possi‐
ble.
Turn off the microwave oven.
Avoid using another microwave oven and the
Remote Control of the appliance at the same
time. Microwaves disrupt Wi-Fi signal.
Remedy
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
Check your network connection. Refer to "Be‐
fore first use" chapter, Wireless connection.
Turn the appliance off and on and try again. Re‐
fer to "Before first use" chapter, Wireless con‐
nection.
Turn the appliance off and on.
Remedy
Turn the appliance off and wait until it cools
down. Turn the appliance on again.
107/344