Electrolux EFLW317TIW Données Techniques page 2

2 Diagnostic Mode Tests
MODE
NUMBER
Lights, Buttons
pre-test
(all models)
Wash compartment
(all models)
Bleach compartment
(all models)
Softener compartment
(all models)
Stain compartment
(no test on 300 series)
(select models)
Door unlock
(all models)
Heater & motor
(no test on 300 series)
(select models)
no test
(push button selector
model)
Recirculation pump
(no test on 300 series)
(rotary ring selector
models)
Concentrate wash
pump
(rotary ring selector
model equipped with
(no test on 300 series)
SmartBoost pump)
Drain pump & spin
(all models)
All valves on
(all models)
Error history
(all models)
* Note for diagnostic mode only: The door is locked in the spin test step, however it can unlock without delay in another test step
or on exiting diagnostic mode, when opening the door the drum can have energy as it spins down.
TEST NAME COMPONENTS UNDER TEST
• LED indicators
• LCD screen
• Button response
• Door lock
• Hot valve
• Door lock
• Bleach valve
• Door lock
• Cold valve
• Bleach valve
• Door lock
• Prewash valve
• Drum light
• Pressure sensor
• Cold valve
• Motor
• NTC
• Door lock
• none
• Recirculation pump
• Pressure sensor
• Cold valve
• Motor
• Door lock
• Drum light
• Concentrate wash pump
• Door lock
• Drum light
• Drain pump
• Motor
• Door lock
• Door lock
• All valves
• The last 3 errors in memory
TEST CONDITIONS
Valve stays on until water level
reaches 140 mm. Then door remains
locked for 5 minutes.*
Valve stays on till water level reaches
140 mm. Then door remains locked for
5 minutes.*
Valve stays on till water level reaches
140 mm. Then door remains locked for
5 minutes.*
Valve stays on till water level reaches
140 mm. Then door remains locked for
5 minutes.*
Drum light turns on when door is
open.
Motor moves after machine fi lls 60mm
of water. Max duration of the test is 8
minutes.
none
Motor moves after machine fi lls 140
mm of water, Recirculation pump
turns on. Max duration of the test is 8
minutes.
Concentrate wash pump turns on for
max 5 minutes. Need power meter
to check for concentrate wash pump
functionality.
Drain pump turns on until empty, then
motor starts spinning until max RPM
for 30 seconds and the door remains
locked for 6 minutes.*
Valves stay on till water level reaches
140 mm, then the door remains
locked for 5 minutes.*
Errors are displayed in order of history
(most recent fi rst)
Note: Pressing temp + set keys togeth-
er clears error history
DISPLAYED FEEDBACK
Number of key pressed.
Note: This number may not
necessarily correspond to
key number on table on
page 1.
Water level
Water level
Water level
Water level
NTC reading
water level
precedes the 2 charac-
ter alarm code, alternating
through the alarms