KIRAMI Original Breezy Mode D'emploi page 25

Masquer les pouces Voir aussi pour Original Breezy:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
25/72
© Kirami Oy, Finland
Minimum fill:
The tub needs to be filled at least 5 cm above the upper
connection pipes of the stove before lighting the fire in the
stove (picture on right).
Do not let a full tub freeze in the winter. Empty the tub or
ensure appropriate heating.
Do not connect the stove to the circulation pump; it cannot
ensure the pressure because it is planned only for
gravitational circulation.
Note about the minimum fill and heating the stove!
The tub stove must never be lighted when the tub is empty or not full! Heating a half-
empty tub will lead to melting the stove! You must not start emptying the tub before the
fire and embers have burnt out completely. Heating a half-empty tub will lead to melting
the stove!
The water is layered when it heats up and, therefore, it needs to be mixed so that the actual
temperature can be found. The optional cover should be in place when heating the water.
Do not leave the water unattended, in case there is a risk of subzero temperatures. The bottom
plugs and exhaust valves need to be left open, so that any water collected in the tub can be
discharged and it will not freeze at subzero temperatures.
You can use 19 mm spanners for the outer edge of the hoop tighteners. These
tighteners are used for adjusting the hoops. You do not usually need to adjust
these in a plastic tub. If the side planks dry and shrink you can adjust the hoops
accordingly. Check that the planks are situated nicely before tightening so that they will not bend
out or in between the hoops and actual tub.
LIGHTING AND HEATING THE STOVE
The use of CULT stoves is as easy as using any other normal stove. The plate in the upper part of
the stove must not be pushed too far so that it prevents the exhaust of the smoke.
Use smaller and dry kindling wood for igniting the fire and then add bigger pieces as needed every
10 to 15 minutes. Maintain the fire in the stove during heating, so that the wood will burn properly
and the tub will heat with maximum power. If the fire is too small, the heating time becomes
remarkably longer.
Empty ashes from the stove after each use, so that grates or air slides will not remain covered by
air slides
the ashes, as it remarkably shortens their life. These grates,
and other inner parts of the
chamber are consumables and not included in the guarantee.
Use only small, dry firewood in the stove. The use of larger and damp firewood may double the
heating time and it will also generate a lot of smoke. We do not recommend black alder because it is
sootier than other wood. It is advisable to adjust the air intake of the stove according to the type
and size of the wood, so as to reduce the amount of smoke.
INSTRUCTIONS FOR USE: Original Breezy hot tubs
5 / 9
05.01.2018

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Breezy mOriginal breezy m

Table des Matières