Seenergy Magic 60 Manuel D'instructions page 7

•
Precaution: burns of accessible parts are likely to occur as they can
get hot when using cooking appliances.
•
Follow the cleaning frequency and filter substitution. The accrual of
fat deposits may provoke fires. Never use the exhaust hood without
the antifat filter.
•
The equipment shall abide by the existing rules on the ventilation of
closed spaces. Technically, the air expelled shall not pass through
the duct used for the discharge of smokes from appliances using gas
or any other fuel (central heating systems, etc...).
•
Ventilate the environment appropriately in case of a simultaneous
operation of the exhaust hood and any other equipment supplied by
an energy source other than electricity so that the exhaust hood will
not draw gas compounds.
•
Attention! During the simultaneous operation of a suction-filtration
exhaust hood and a heating system independent of air (gas heaters,
oil, coal, chimney, etc...), great attention has to be placed so as to
avoid that the exhaust hood does not absorb part of the air intended
for the combustion process since dangerous amounts of carbon
monoxide may surge within the premises, that would represent a
life-threatening danger. When installing an exhaust hood joined or
connected to a fuel element such as a heater, chimney or local
heating system, it is mandatory to contact the producer or installer
of such elements to obtain an optimal and risk-free operation.
•
It is necessary to maintain a depressurized environment of
maximum 0.04 mbar. Such conditions allow an excellent working of
the exhaust hood. In order to achieve such environment a
permanent air intake is necessary in order to avoid air stagnation (it
is advised to use a ventilation grid for this purpose). Windows or
doors shall not be used.
•
The electrical supply of the power network shall be stable and cope
with the indicated electrical standards, 220/240v AC, 50Hz. Should
it be not stable and receive voltage variations in the supply, intensity
or frequency such as armonici, transistor, voltage dips, overloads,
WARNINGS
EN/3