Seenergy Magic 60 Manuel D'instructions page 6

power supply terminals which shall have a separation of the contact
between poles so as to interrupt the supply of electricity in case of
overvoltage category III).
•
Once the equipment has been installed, the disconnection of the
equipment from the power supply shall be allowed. Disconnection
can be done by keeping the jack accessible or adding a switch to the
electric system in accordance with the installation rules.
•
If the power cord is damaged, it shall be replaced either by the
producer, its customer service or qualified personnel in order to
avoid risks.
•
It is of vital importance to place particular attention as to where the
wall or ceiling will be perforated so as to verify the presence of
hidden electrical cables, pipes or iron beams, etc. This may cause
serious breakdowns, electrical derivations or the transmission of
noises and vibrations.
•
IMPORTANT: During the installation phase, before electrically
connecting the equipment, always disconnect the power panel
that will supply it (differential or thermal-magnetic of the general
house switchboard).
•
WARNINGS: Always disconnect the exhaust hood from the
electrical outlet before proceeding to cleaning and maintenance
operations by plugging off the electrical outlet, differential or
thermal-magnetic of the general home switchboard. To clean the
exhaust hood, never use steam or high-pressure devices (rules
regarding electric safety).
•
It is forbidden to cook directly on the flame or operate the gas stoves
with no container to cook on the same flame (aspirated flames may
damage the equipment and the warranty will be cancelled
accordingly). The use of the equipment on a fuel stove is not
authorized (wood, coal,...).
•
Frying under the equipment shall be constantly monitored since oils
and fats being subjected to high temperatures may ignite. Do not
flame under the exhaust hood.
WARNINGS
EN/2