Seenergy Magic 60 Manuel D'instructions page 44

Procedure for fixing
Dimensional Drawings
Fix the hood as shown in the scheme
Connecting and fitting
Before connecting the appliance, check the household installation.
Appliance without power cable:
necessary, fit the copper bridge supplied. Mains power cable: Type H05 VV-F or a
higher grade, min. wire cross-section 1.5 mm2.
Appliance with prefitted power cable:
trained after-sales engineer.
Installing: Do not trap the power cable and do not route it over sharp edges. If the
oven is a built-under type, route the cable on the rear corners of the oven to the
socket.
INSTALLATION
Only connect as shown the connection diagram. If
The power cable must only be replaced by a