Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When storing the encoder, make sure that the shaft and the
cable outlet are always free from any load.
The device must be stored at a dry and dust-free location, in
compliance with the technical data, see chapter
Technical Data [} 17].
2.4 Use According to the Intended Purpose
The encoder can be used as a rotation angle, position or
speed sensor.
The encoder supports functions based on speed and rotation
direction information, e.g. in industrial processes or controls.
The measuring system and its evaluation unit must meet the
requirements mentioned in chapter Technical Data [} 17].
2.5 Foreseeable Misuse
The measuring system is not suitable for the following uses:
• Under water.
• In publicly accessible areas.
• Outside of the specifications stated in the data sheet..
• In areas where more serious EMC events may occur than
those defined in the standard.
16 - EN
2.6 Other Applicable Documents
Reference to the data sheet
All technical data, as well as the mechanical and electrical
characteristics, are specified in the data sheets of the corres-
ponding device variant, for special versions in the.corres-
ponding customer drawing of the product.
Refer to the further descriptions in the manual of the product.
The above mentioned documents, the original declarations of
conformity and the relevant certificates can be downloaded
from our homepage:
www.kuebler.com/docufinder
3 Product Description
3.1 Function of an Encoder
An encoder is a measuring device that converts rotational
movements into electrical signals. A distinction is drawn
between incremental and absolute encoders. Both deliver dif-
ferent output signals:
• Incremental encoders:
Equivalent pulse sequences whose number is proportional
to the traveled rotation angle.
• Absolute encoders:
Digital information, that is to sat that every angular position
is a unique bit pattern.
BA Sendix® Base KIS40/KIH40 - R60087.0009 - 01
NOTICE
.
Publicité
Table des Matières
