Sony SU-B550S Mode D'emploi page 6

Note on taking the TV Stand out from the carton
Be sure to hold the TV Stand and handle it carefully.
Step 1:
Checking the parts
Name
Stand
*
Rear Cover
Joint
TV Stand Neck Attachment Screw
(PSW5 × 16) black (× 3)
Joint Screw
(PSW5 × 16) black (× 3)
AC adapter
AC power cord (mains lead)
High Speed HDMI cable
Cable holder
Instructions manual
Warranty card
* For SU-B550S model only.
WARNING
If you allow the AC power cord (mains lead) to be pinched under
or between pieces of equipment, this may result in a short circuit
or an electric shock. If you stumble over the AC power cord
(mains lead) or the connecting cable, the TV Stand may topple
over and cause injury.
Decide on the installation location and lay the TV
Stand down before installing the TV.
Since the TV is heavy, it is recommended that you decide on the
installation location beforehand, and assemble the TV Stand on
site.
Refer to the operating instructions supplied with your TV for
information on how to remove the Table-Top Stand from the TV.
6
(GB)
Step 2:
Installing the TV
Before assembling
• Be sure to have a Phillips screwdriver that fits the screws prior to
the assembly.
• When using an electric screwdriver, set the torque setting to
approximately 1.5 N·m {15 kgf·cm}.
Quantity
1
Hold the TV at the specified point
when moving the TV.
1
Make sure to hold the TV as shown:
2
1
6
~
• When transporting the TV set by hand, hold it as shown
2
Remove the screws from the
1
Joint on the rear of the TV.
1
Slide the Joint down to detach.
1
Soft cloth
~
• Make sure to keep the removed screws.
• When removing the Table-Top Stand from the Display, lay
• To prevent damaging the surface of the LCD display, make
above. Do not put stress on the LCD panel and the frame
around the screen.
the display face down on a stable work surface that is larger
than the Display.
sure to place a soft cloth on the work surface.
Joint