Kärcher NT 40/1 Tact Mode D'emploi page 14

Device elements
1 Electrodes
2 Suction hose
3 Push handle
4 Carrying handle
5 Filter cover
6 Cable hook
7 Air outlet, working air
8 Suction head lock
9 Wheel
10 Air inlet, motor cooling air
11 Dirt receptacle
12 Steering roller
13 Suction head
14 Chassis handle
15 Suction support
16 Floor nozzle
17 Suction tube
18 Bender
19 Rotary switch for suction output (min-max)
20 Indicator lamp
21 Socket
22 Automatic filter dedusting
23 Main switch
24 Power cord
25 Flat fold filter
26 Filter dedusting
27 Floor nozzle holder
28 Fastening screws for slider
29 Holder for suction pipes
30 Holder for crevice nozzle
31 Nameplate
Caution
The flat pleated filter must always be in
place while vacuuming.
Anti-static system
Only for appliances with built-in socket:
Static charges are dissipated by the
earthed nozzle. Sparks and current pulses
are thus prevented with the optional con-
ductive accessories.
14
Start up
Dry vacuum cleaning
To vacuum fine dust, you can also use
–
an additional paper filter bag, a fleece
filter bag (option) or a membrane filter
(option).
Installing the paper filter bag/fleece filter
bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag, fleece filter
bag (option) or membrane filter (option).
 Insert and lock the suction head.
Wet vacuum cleaning
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag/fleece filter
bag
If the appliance is used to vacuum wet
–
dirt, the paper filter bag, the fleece filter
bag (option) or the membrane filter (op-
tion) must always be removed.
It is recommended to use a special filter
–
bag (wet) (see Filter systems).
General
If wet dirt is vacuumed with the uphol-
–
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the flat
–
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
– 2
EN