Makita LC1230 Manuel D'instruction page 7

Switch action
1
► 1 . Lock-off button 2. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
• When not using the tool, remove the lock-off
button and store it in a secure place. This pre-
vents unauthorized operation.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, depress the lock-off button and pull the
switch trigger. Release the switch trigger to stop.
Setting for desired cutting angle
CAUTION:
• Always tighten the hex bolt securely after
changing the cutting angle.
1
2
► 1 . Graduation 2. Lever 3. indicator 4. Vise stop
To change the cutting angle, loosen the lever. Move the
vise stop so that the indicator will point to the desired
graduation. Then tighten the lever to secure the vise
stop.
Dust collection
CAUTION:
• Do not touch any part of the dust box except its
handle immediately after operation; it may be
extremely hot and could burn your skin.
2
► 1 . Dust box
This tool is equipped with the dust box to collect dust
and cut chips. When the dust box is full, hold the han-
dle of the dust box and raise it slightly. Then pull the
dust box out of the tool base. Empty the dust box of its
contents.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
3
Socket wrench storage
1
4
2
► 1 . Wrench holder 2. Base
The socket wrench is stored as shown in the figure.
When using the socket wrench, pull it out of the wrench
holder. After using the socket wrench, return it to the
wrench holder.
7 ENGLISH
1