Technical Documentation; Intended Use; Electrical Safety Information On Installation And Start-Up - emk DRACO Notice De Montage

Technical Documentation

The following technical documentation includes documents on the intended use, the electri-
cal and product-related safety, installation and operating instructions as well as information
on the delivery, scope of delivery, maintenance and disposal.

1. Intended Use

The Design infrared radiator is only to be installed in living areas as a wall or ceiling ele-
ment. Special measures must be taken for installation in bathrooms (Section 2). Any non-
compliance can lead to significant damage to people and the environment. The Design
infrared radiator is not intended to be used by people (including children) with limited physi-
cal, sensory or mental abilities or by those lacking experience and/or knowledge unless they
are supervised by a person responsible for their safety or have received instructions from
them on how to use the device.
Children must be supervised to ensure that they do not play with the device.

2. Electrical Safety Information on Installation and Start-up

▪ The Design infrared radiator is only to be connected to a 230 V ~/ 50 Hz socket.
This should be easily accessible to disconnect the infrared radiator from the mains.
▪ Plug and mains cable as well as the front should not have any damage.
▪ Electrical devices must generally be at least 0.6 m away from the next water connection.
▪ Design infrared radiators may not be placed directly underneath electrical sockets.
▪ Observe the information on minimum distances to other objects which is given in the
installation instructions.
▪ In accordance with VDE0100-701 (areas in bathroom), room heating devices such as the
Design infrared radiator, may not be used in the immediate area of a bathtub, a shower
or a swimming pool. Moreover, it should be observed that when installing the room hea-
ting devices in bathrooms, the switch and regulator are to be installed or mounted so that
they cannot be accessed by a person in the bathtub or shower.
▪ The Design infrared radiator may not be covered because overheating danger exists.
▪ When cleaning the Design infrared radiator, the device must be switched off. Disconnect
the plug from the mains socket or turn off the off button on the thermostat.
EN
13