Publicité
Quick reference guide
This high pressure washer has been designed for
professional use typically in following cleaning ap-
plications:
floor/wall, auto/truck, buildings/constructions, con-
tainer/barrel and craftsman use.
The pictorial quick reference guide
The pictorial quick reference guide is designed for
helping you when starting up, operating and storing
the unit. The guide is subdivided into 5 sections.
Before starting
DO READ SAFETY INSTRUCTIONS BEFORE USE!
Operating elements:
1. Inlet water connection
2. Nipple for high pressure hose
3. Lifting handle
4. Hose holder
5. Cable
6. Oil plug
7. On/off switch
8. Oil reservoir
9. Lock for oil reservoir
10. Feet (rubber dampers)
11. Lance (2nd optional)
12. Holder for lance
13. Ergo 2000 spray handle
14. Child lock
15. Foam Sprayer
16. Holes for wall mounting (x2)
Wall mounting
Only mount the machine on a solid wall construction
suitable for machine assembly, for example a con-
crete or brick wall.
Do not install the machine where it can be an incon-
venience to adjoining rooms (canteen / office etc.).
Preparation for stationary use
1. Dismount rubber dampers, pos. 10.
2. Dismount oil plug, pos. 6.
3. Mount oil reservoir, pos. 8.
4. Mount lock for oil reservoir, pos. 9.
5. Top up with oil.
6. When the oil container is filled up, tilt machine to
the side.
When the oil in the oil container stops sinking,
raise the machine to upright position and refill
the oil container to the correct filling mark on the
container.
Switching on the unit
1.0
Connect hoses (water and high pressure
hose).
1.1
Mount the lance.
Original instructions
A
B
1.2
Connect the electrical cable to mains.
1.3
Check oil level.
1.4
Open water tap.
1.5
Switch on the high pressure washer.
1.6
Open child lock at spray handle.
1.7
Activate spray handle.
Control/operation
Using cleaning agents:
1.0
Check / clean hole in suction limiter at foam
sprayer.
1.1
Mount foam sprayer at canister.
1.2
Set spray angle horizontal/vertical.
1.3
Activate spray handle.
Adjust pressure at FlexoPower lance:
2.0
Turn the blue part of the nozzle head min./
max.
Hose and c able:
During use, cable and hose MUST be completely
unwound.
After using the unit
1.0
Switch off the high pressure washer.
1.1
Disconnect from mains.
1.2
Turn off the water.
1.3
Release pressure at spray handle
1.4
Set child lock.
Maintenance
1.0
Check / top up with oil to max (SAE 80W-90).
C
D
E
7
Publicité
