Fill With Water - Blue Wave NP5760 Manuel D'instructions

NP5760

6. Fill with Water

Check the stopper on the bottom of the pool and the drain cap, and make sure both of them are tight.
Fill the pool with water from a garden hose until reaching the water level mark printed on pool inner wall.
Part IV
1. Press the temperature setting button to select the desired temperature. Press the heating button to heat
the water. Put on the cover while heating. If there is an inflation lid included with your SPA pool, put it below
the cover.
When the water temperature reaches your set temperature, you can enjoy your SPA. Pressing the bubbling
button to activate the massage system.
We suggest an appropriate temperature is around 100°F (38°C) to 104°F (40°C). It is not good for your health
to exceed 30 minutes in the SPA. Taking that into account, the massage system will stop automatically after
30 minutes of operation. Re-activate the massage function by pressing the massage button again.
Temp. setting
Bubble
Heating
Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal
body temperature of 98.6°F (37°C). The symptoms of hyperthermia include drowsiness, lethargy, and an increase
in the internal temperature of the body. The effects of hyperthermia include:
(a) unawareness of impending hazard;
(b) failure to perceive heat;
(c) failure to recognize the need to exit spa;
WARNING: THE USE OF ALCOHOL OR DRUGS CAN GREATLY INCREASE THE RISK OF FATAL
HYPERTHERMIA IN HOT TUBS AND SPAS.
WARNING: WATER TEMPERATURES IN EXCESS OF 100°F (38°C) CAN BE HAZARDOUS TO YOUR
HEALTH.
8
Usage
If you want to use the pool without the pump, use the stopper
caps to prevent the water from running out of the pool.
LED display
Control panel
"Temperature Mode" button
Filter
SPA with Cover On
(d) physical inability to exit spa;
(e) fetal damage in pregnant women; and
(f) unconsciousness and danger of drowning.