Blue Wave NP5760 Manuel D'instructions page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. GFCI Test
WARNING: RISK OF ELECTRIC SHOCK. The GFCI plug must be tested before each use.
DO NOT use if GFCI test fails.
Insert the plug into the power outlet.
Press the "RESET" button, the indicator light turns red.
Press the "TEST" button, the indicator light turns off.
Press the "RESET" button, the indicator light turns red and the pump is ready to use.
1
3. Assemble SPA Pool
1) Take the body of the spa and
position it where the footprint of
the spa will be.
4) Connect the other end of the inflation hose to the spa body. Press the bubble button to inflate the spa.
5) Walk around the spa and pull the inner cover of the spa body. Use your hands to spread out the inner
cover completely.
4. Connect the Pump to the SPA Pool
Remove the inflation hose and attach the connection hoses of pump to the pool according to the icons
of filtering function, heating function and bubbling function on the pool and the pump.
5. Install the Filter Cartridge
Make sure the filter cartridge is in the cover, then screw the filter cartridge onto the lower suction fitting.
2
2) Take the spa pump and the
inflation hose and position them
next to the spa body.
spa is plugged in, or spa will NOT start.
3
3) Connect one end of the
inflation hose to the spa pump.
NP5760
7

Publicité

Table des Matières
loading

Table des Matières