Johansson Profiler Lite 6601 Mode D'emploi page 8

- Turn the button to select the desired mode.
- Push the rotary button to enter the selected mode.
- Inside the mode, turn the button to select the parameter (input, cluster, channels, level...)
- Push the button to confirm the parameter setting.
Exit programming mode
- Turn the button to select Exit mode.
- Push the button more than 3 seconds to confirm.
3sec.
- Turn the button to select
- Push the button to confirm.
Note :
The amplifier will go in "stand-by" and will display a dot after 1 minute if the rotary / push button is not activated.
Repeat this section to set all parameters
I-II III 1
The LED is red and 2 dashes are displayed
Free access
to progamming
mode
8
Mode is indicated with
a GREEN colored LED.
The LED is now RED colored.
Input and Cluster LEDs
2 3 4 5 6 7 8 9 10
UHF Clusters
Display
LED returns to a GREEN color.
Exit
The LED is green.
Exit
or
Access to
progamming mode
with security code "50"
A dot is displayed
= green LED
= red LED