Reliable EnviroMate Flex EF700 Guide D'utilisation page 19

• This industrial steam vacuum
generator does not require any
particular maintenance. It may be
necessary to empty the water out
of the boiler to remove any lime
scale deposits. Loosen the cap
on the base using the special tool
supplied (3 Fig. 1). Only do so
when unit is cold.
• Be sure to re-close the cap
once the water has been totally
discharged (Fig. 28).
CLEANING/EMPTYING THE
VACUUM CLEANER
• After each use, or when one
notices a change in the running
noise or should it fail to vacuum,
it will be necessary to empty the
drum (Fig. 29).
• Remove the vacuum from its
compartment (Fig. 30).
• Unlock the two side hooks of
the vacuum device and lift the
vacuum head.
• Empty and clean the vacuum
cleaner (Fig. 30).
• Remove the filter (1 Fig. 31),
installed below the head, by
loosening the fixing cap (2).
• Clean with running water checking
whether it is intact. If visibly
damaged, replace it.
• Replace the vacuum
compartment (Fig. 31/30)
making sure to insert the plug into
the relative socket should it have
been previously removed.
(Fig. 29)
(Fig. 30)
(Fig. 31)
19